- INSTRUMENTS
- TruBurst
-
INSTRUMENTS
- Titan 4, 5 and 10
- TruBurst
- ThermaPlate
- Colour Assessment Cabinets
- Sample Cutters
- Titan 1 2 3
- FlexiBurn
- TruFade
- ElastAbrasion
- Spray Rating Tester
- Martindale
- Orbitor
- GyroWash
- Perspirometer
- DynaWash & DynaWash Duo
- SnagPod
- FlexiFrame
- CrockMaster
- ElmaTear
- Impulse
- Wascator
- ProView
- ProMace
- AccuDry
- Crease Recovery Angle Tester
- Apollo
- Wrinkle Recovery Tester
- Titan
- DynaWash
-
OPERATOR'S GUIDES
- Memmert Incubator IN30
- GyroWash
- CrockMaster
- Spray Rating Tester
- ElmaTear
- Titan
- Martindale 900 Series
- AquAbrasion 1819
- TruFade
- Martindale 1600 Series
- SnagPod
- Perspirometer
- Wascator
- TruBurst
- DynaWash & DynaWash Duo
- Orbitor
- Crease Recovery Angle Tester
- Martindale 1300 Series
- Yellowing Test Kit
- Tautex
- ElastAbrasion
- ThermaPlate
- FlexiBurn
- Incubator / Oven
- AccuDry
- Martindale model 103
- Wrinkle Recovery Tester
- Drape Tester
- ProMace
- Sample Cutters
- Sock Abrasion Kit
- Impulse
- ProView
- FlexiFrame
- General
- INSTALLATION GUIDE
- ProDry
- WickView
- TruRain
- AirPro - Air Permeability Tester
- HydroView - Hydrostatic Pressure Tester
-
TEST MATERIALS
-
EU DECLARATION OF CONFORMITY
-
MATERIAL SAFETY DATA SHEETS
-
GENERAL
-
Filters
Which Burst Detection Setting should I use on TruBurst?
There are 5 levels of burst detection settings: very low, low, normal, high & very high.
The settings should be on normal unless the user finds difficulty achieving a result for example with stretchy fabric that bursts near the top of the dome. In this case, the setting should be increased in stages until a result is achieved.
If a fabric is very stretchy it may not burst. In this case it should be reported that the fabric fills the dome and does not rupture.

The EDIT button through the TEST screen allows for alteration of test settings.
This screen can also be accessed after standard selection – press EDIT on the blue bar and then MORE.
